Scribing Drywall to Fit
One example of scribing is hanging drywall next to the irregular stonework of a fireplace. Trying to measure and transfer all of the irregularities to a sheet of drywall would require saintly patience and a lot of time. But if you know how to scribe, you’ll produce accurate results within minutes. To cut a piece of drywall to fit against an irregular surface, hold the piece near the surface and trace the outline onto the sheet, using a wood scrap and a pencil as a scribing tool.
Scribing a Wood Molding
Scribing also works well for sheets of wood products, countertops, moldings, and other trim boards. If a wall has a slight bow to it, for example, you probably won’t be able to muscle a 1x4 applied flat into the arc. Although pumping a caseload of caulk into the gap is one solution, scribing is more sensible and less expensive.
Step 1: Make Cut Line
Place the wood near the wall and parallel to it. Lock your bow compass at a setting that spans the gap, even at the widest point. Holding the compass at a consistent angle, draw it down the wall, marking the board. In this case, the edge of the compass, not its point, rides along the wall.
Step 2: Sand to Fit
Securely clamp the scribed board to your worktable, then sand to the scribed line. Tilt the sander slightly backward to undercut the line for a snug fit against the wall. A coarse belt works best. If you have a lot of stock to remove, cut with a jigsaw just to the waste side of the line, removing the bulk of the material before sanding.
Fitting Angled Pieces
Another common problem deals with fitting angled pieces of sheet goods. Die-hard engineers will reach for their calculator and trig tables. But the rest of us will get faster results with a tape measure, straightedge, and no math with the following procedure.
Step 1: Get Measurements
Rather than measuring the angle at which a piece must be cut, measure the length of the horizontal run and the vertical rise.
Step 2: Make Cut
Transfer the measurements to the drywall, then draw a cut line between the two marks. Cut and snap the piece along the line.
